You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
cnc4newbie's C4N Controller
print icon

Wiring up your C4N controller as follows:

White and Yellow wire up to SP RELAY

Red into + and Black into -

Orange and Green -> tape-off

 

 

 

For configuring your UCcnc software you’ll want to adjust your

Configuration -> Spindle settings to match these:

 

 

New VFD's that come with this quickstart guide will already have this configured... but if your quick start guide was "Other"... then you'll want to verify these two VFD Parameters:

 

P0.0.03 = 1

P2.0.02 = 21

 

These parameters basically tell the VFD to listen to the White and Yellow wires... and when triggered to activate the forward function.

 

 

Feedback
0 out of 0 found this helpful

scroll to top icon